Cam Tab Alignment Tools

Install your new cam tabs quick and easy, with the KPO Alignment Tool!

Our cam tab alignment tools are designed to help perfectly align your new KPO cam tabs to your frame. We use the same tools in our own shop and have proven they make installing your cam tabs much quicker and easier than trying to align the plates by hand! These tools are 3D printed in house out of PLA and are designed for TACKING the cam tabs onto the frame only. DO NOT leave the tool installed while fully welding the cam tab plates to your frame.

What's included:

Each platform uses different cam tab sizes, with most platforms using multiple sizes per vehicle. Here is a helpful chart on what's included with each platform:

96-02 4Runner, 95-04 Tacoma, 00-06 Tundra, 01-07 Sequoia:

• X1 3/4" 19MM Alignment Tool

03-09 4Runner / GX470, 05-15 Tacoma, 07-09 FJ Cruiser:

• X1 9/16" 14MM Alignment Tool
• X1 3/4" 19MM Alignment Tool

10-24 4Runner / GX460, 16-23 Tacoma, 10-14 FJ Cruiser:

• X1 5/8" 16MM Alignment Tool
• X1 20MM Alignment Tool

07-21 Tundra, 08-22 Sequoia:

• X1 18MM Alignment Tool
• X1 23MM Alignment Tool

All Models (intended for shops who install multiple models):

• X1 9/16" 14MM Alignment Tool
• X1 5/8" 16MM Alignment Tool
• X1 18MM Alignment Tool
• X1 3/4" 19MM Alignment Tool
• X1 20MM Alignment Tool
• X1 23MM Alignment Tool

Install Process:

When welding on your new cam tabs, it is important that they align perfectly with the slot on your frame. If the slots are not aligned the LCA bolt will not be able to fully seat in one direction or the other. We designed these tools to be as quick and easy to use as possible while ensuring the slots align perfectly during install. Consult the photos above and the list of directions below:

1. Prep- Remove all old cam tab plates, and prep/clean frame for install.
2. Assemble- Using the correct alignment tool for each plate (as some vehicles use multiple sizes), assemble new tab plates and tack together, ensuring snug fitment. Remove alignment tool so it doesn't melt, THEN finish welding.
3. Verify & Cool Down- If your vehicle uses multiple sized plates, confirm where each size has to go and note their locations. Allow plates to cool before proceeding.
4. Sandwich Together- Insert tool back into matching tab assembly, then key into the matching frame slot to align into place. Double check correct tab/frame location and tack into place, then remove tool. Repeat for all 8 assemblies.
5. Finish welding in your new plates, triple checking the correct tab/frame location beforehand, then allow to cool and coat thoroughly to prevent rust. Enjoy a perfect, permanent alignment!

Disclaimer: Cam tabs should be installed by a shop with off road/welding experience only. Designed for KPO cam tab plates; using with other brands may require modification.