Cabin Vent Cover
Cabin Vent Cover
Cabin Vent Cover
Cabin Vent Cover
Cabin Vent Cover
Cabin Vent Cover
Cabin Vent Cover
Cabin Vent Cover
Cabin Vent Cover
Cabin Vent Cover
Cabin Vent Cover
Cabin Vent Cover
Four Cam Engineering

Cabin Vent Cover

$39.99

Compatible with 1996-2002 4Runners, 2010+ 4Runners and GX460s

So you hit the trails last weekend, and now you get to deal with that routine dust all over your interior. Or maybe you played in some water and now your trunk is soaked. Windows were up, vents were on 'recirculate'... how does this always happen?

Toyota designed their vehicles with cabin pressure vents, to allow the air pressure to escape when you close your doors or run the AC/heater. Without these vents, your doors would be hard to shut and your AC would barely blow. The air has to go somewhere after all! But the problem with these one-way vents is that they are down low on your rear quarter panel, and they are flimsy. It only takes a few years of off-road use to break them down. Then that one-way valve becomes an open window for air, water and dust to get in.

Four Cam Engineering has finally solved this problem for us, and created the Cabin Vent Solutions for Toyota SUVs.

 

Product Details:

The Vent Cover is great option if your original cabin vent is still functional, and you want to keep it that way. The Cover protects your Vent from dust and debris buildup (the primary cause for vent failure). It is also a great way to improve aesthetics if your vent is exposed after removing the stock bumper.

  • 96-02 models include 1 Four Cam Cover (driver side)
  • 2010+ models include 2 Four Cam Covers (driver and passenger sides)
  • 3D Printed from PETG, which was chosen for its durability, quality, higher melting point and weather resistance
  • Designed with water drain holes and air slots, to allow for door seal and AC function while providing maximum protection
  • Installation may require slight sanding to seat to your factory vent. The use of a strong weather-proof super glue, epoxy, or plastic weld is highly recommended.


    01-02 4Runner owners: you will need to determine if your cabin vent has a tow harness coming out of it before making your selection. If your vehicle came with a tow package from the factory, it most likely has a vent with a tow harness.

     

    NOTE: Factory vent failures are very common! Check your Vents before ordering a Cover only. If there is any visible damage, we strongly recommend getting a new Vent. The Cover's main purpose is to provide protection so the Vent can do its job. Installing a Cover to a damaged Vent is just a "bandaid" fix... Do it right the first time!

     

    Warranty and Disclaimer Information

    All kits are protected under Four Cam Engineering's Lifetime Warranty. In the unlikely instance that your kit fails, we will send you a new kit free of charge. Covered failures include breakdown of layer adhesion, material degradation, warping from extreme heat or extreme color fading (minimal fading is normal for plastic parts in general).

    Warranty does not cover failure of adhesion or vent cover falling off due to a glue or method that customer used during installation. We do not replace covers or vents due to damage from off-roading, incorrect install, or misuse. While we experienced a total prevention of dust during our testing phase and to this day, it would be impossible to guarantee this for everyone. There are simply too many variables across individual vehicles.

    As with all 3D printed parts, some minimal irregularities in the finish are common. We implement extensive quality control measures, but occasionally visual characteristics will still be present. Characteristics may include: faint streaks or lines imprinted on the face of the cover, layer lines on sides of cover, stringing, or loose filament strands.